The electrical engineer should take full account of the site location and environmental conditions that a gas turbine generator will need to endure. These conditions can seriously affect the electrical power output that will be achievable from the machine. The starting point when considering the possible output is the ISO
Author: Engr. Aneel Kumar
The fuels usually consumed in gas turbines are either in liquid or dry gas forms and, in most cases, are hydrocarbons. In special cases non-hydrocarbon fuels may be used, but the machines may then need to be specially modified to handle the combustion temperatures and the chemical composition of the
There are basically two gas turbine driving methods, known as ‘single-shaft’ and ‘two (or twin) shaft’ drives. In a single-shaft gas turbine, all the rotating elements share a common shaft. The common elements are the air compressor, the compressor turbine and the power turbine. The power turbine drives the generator.
At the earliest practical time in a project the engineers will need to identify areas of engineering and design where interfaces are necessary. An efficient system of communication and exchange of information should be established and implemented at regular intervals. Meetings should be arranged to discuss problem areas and short-falls
• Switchboards and motor control centre name and tag number. • Bus-section numbers or letters. • Cubicle numbers or letters. • Line voltage, number of phases, number of wires, frequency, busbar continuous current rating. • Busbar nominal fault breaking capacity in kA at 1 or 3 seconds. • Identification of
Single-line diagrams are the most essential documents that are developed during the detail design phase of a project. They identify almost all the main items of power equipment and their associated ancillaries. Initially they define the starting point of a project. Finally they are a concise record of the design,
The rating of a motor should exceed that of its driven machine by a suitable margin. The selection of this margin is often made by the manufacturer of the driven machine, unless advised otherwise. The actual choice depends on various factors e.g. Approximate rating of the motor or machine (kW)
Some basic and important points, in relation to a modern power system, are summarized below: 1. Generation, transmission and distribution of electric power in our country is carried out as 3-phase system at 50 Hz. 2. Three most important conventional methods of power generation in out country are: coal based
Nuclear power plants are thought to be the solution for bulk power generation. The present day atomic power plants work on the principle of nuclear fission of 235U. In the natural uranium, 235U constitutes only 0.72% and remaining parts is constituted by 99.27% of 238U and only about 0.05% of
In a hydral power station, water head is used to drive water turbine coupled to the generator. Water head may be available in hilly region naturally in the form of water reservoir (lakes etc.) at the hill tops. The potential energy of water can be used to drive the turbo
