Skip to main content

RELAYS

Relays are used extensively in modern vehicles. They can be thought as electro/mechanical switches. They are often used to switch on circuits that require a heavy current e.g. the heated rear windscreen (H.R.W.) circuit.

If a relay was not used the contacts inside the HRW switch would need to be quite large to carry the heavy current. By using a relay, smaller switch contacts can be used. The relay then acts as a switch saver.

Relays can be used to avoid voltage drop and reduce the amount of heavy duty cable required. They can also ensure that contacts make and break cleanly. Relays also make a convenient point for testing individual circuits.

From the circuit diagrams with circuit A the HRW switch has to carry the full current. However, with circuit B the HRW switch only needs to carry enough current to activate the relay. When the relay is activated it closes the relay switch. The feed for the HRW then comes through the 16 amp fuse and the contacts of the relay. By taking this route it saves the contacts of the HRW switch.

Circuit B has the advantage that the relay switch can be located almost anywhere in the vehicle. With circuit A, if the switch was mounted too far away from the heated rear window, it could cause pressure loss i.e. voltage drop.

Circuit A

Circuit B

Comments

Post a Comment

Popular posts from this blog

ADVANTAGES AND DISADVANTAGES OF CORONA

Corona has many advantages and disadvantages. In the correct design of a high voltage overhead line, a balance should be struck between the advantages and disadvantages. ADVANTAGES (i) Due to corona formation, the air surrounding the conductor becomes conducting and hence virtual diameter of the conductor is increased. The increased diameter reduces the electrostatic stresses between the conductors. (ii) Corona reduces the effects of transients produced by surges. DIS-ADVANTAGES (i) Corona is accompanied by a loss of energy. This affects the transmission efficiency of the line. (ii) Ozone is produced by corona and may cause corrosion of the conductor due to chemical action. (iii) The current drawn by the line due to corona is non-sinusoidal and hence non-sinusoidal voltage drop occurs in the line. This may cause inductive interference with neighboring communication lines.
Read more

ADVANTAGES OF PER UNIT SYSTEM

PER UNIT SYSTEM The per-unit system expressed the voltages, currents, powers, impedances, and other electrical quantities basis by the equation: Quantity per unit (pu) = Actual value/ Base value of quantity ADVANTAGES OF PER UNIT SYSTEM While performing calculations, referring quantities from one side of the transformer to the other side serious errors may be committed. This can be avoided by using per unit system. Voltages, currents and impedances expressed in per unit do not change when they are referred from one side of transformer to the other side. This is a great advantage. Per unit impedances of electrical equipment of similar type usually lie within a narrow range, when the equipment ratings are used as base values. Transformer connections do not affect the per unit values. Manufacturers usually specify the impedances of machines and transformers in per unit or percent of name plate ratings. Transformers can be replaced by their equivalent series impedances. ...
1 comment
Read more

ABSOLUTE AND SECONDARY INSTRUMENTS

The various electrical instruments may, in a very broad sense, be divided into (i) Absolute Instruments (ii) Secondary Instruments. Absolute Instruments are those which give the value of the quantity to be measured, in terms of the constants of the instrument and their deflection only. No previous calibration or comparison is necessary in their case. The example of such an instrument is tangent galvanometer, which gives the value of current, in terms of the tangent of deflection produced by the current, the radius and number of turns of wire used and the horizontal component of earth’s field.  Secondary Instruments  are those, in which the value of electrical quantity to be measured can be determined from the deflection of the instruments, only when they have been pre-calibrated by comparison with an absolute instrument. Without calibration, the deflection of such instruments is meaningless. It is the secondary instruments, which are most generally used in ev...
Post a Comment
Read more